-
When processing on CNC machine, the program is programmed according to the part drawing. The programming code and command pattern mostly conform to the ISO standard and the corresponding national standard.
-
The automatic CNC lathe parts are programmed. After the good tool, it is necessary to carry out trial and error debugging.
-
1. Fully enclosed, no pipelines exposed, neat and beautiful.
2. The servo motor's rapid feed rate can reach 20 m / min.
-
The rigidity of the machine tool is good, and it is not easy to cause vibration. The cross-sectional area of the CNC lathe is much larger than that of the flat bed of the same specification
-
The economical CNC lathe adopts the stepping motor and the single-chip microcomputer to transform the feeding system of the ordinary lathe into a simple CNC lathe, which has lower cost, but the degree of automation and function are relative
-
The experience of CNC lathe manufacturers has learned that the position loop is bad and causes the output voltage to be unstable; the vibration caused by the poor speed loop;
-
When processing on a small CNC lathe, the program is based on the part drawing program. The programming code and command pattern mostly conform to the ISO standard and the corresponding national specifications.
-
Talking about the High Precision Machining Technology of Shandong CNC Lathe
-
In addition to the industry standard, the small CNC lathes produced in China have the advantages of small CNC lathes.
-
After finding the problem of numerical control lathe, even if the local position has been found, it should not be repaired blindly. First,
-
In order to prevent rust, the sliding surface of the CNC lathe and some metal parts are coated with rust inhibitor.
-
The CNC lathe is mainly composed of a machining program carrier, a numerical control device, a servo system, a machine tool body and other auxiliary devices.
